X
Shopping Cart 0 Items 0.00
Your position: Home / Dolls Care & Maintenance

Dolls Care & Maintenance

Operating and maintenance instruction


1. The exterior layer is made of high standard elastic property TPE(thermoplastic elastomers) coupling with epoxy resins infirm body support and finely crafted skeleton. All materials complied with national health and safety standards which is harmless to humans and is environmentally friendly.

2. The skeleton and joints allow the model to pose in many positions and styles. With a little imagination, she can be very human. For durability, do not position at highly stretched positions over a long period of time. Although the elasticity of TPE material is marvelous, excessive stretching for long periods of time might result in deformation. Please reposition the model to its original position, with hands rested downward, after use.

3. It is a standard procedure during manufacturing to mount and position its skeleton at precise points. Various supports were attached during the injection process, thus there will be some small fillings to these holes which are not classified as manufacturing defects.

4. Avoid sharp objects or kneading with excessive strength.


5. Strongly advice to test colors fading of dresses prior to wearing onto the model. Should particular dresses have a sign of fading, please do not wear onto the model as stain could hardly be removed. We shall not be responsible for its consequences.

6. Do not expose the model under sunlight for a long period of time. This might increase the aging of TPE material and life spends of the model.

7. Should creasing or pressure mark occurs, may apply a warm towel to the creased area.

8. Dust and dirt may be cleaned with a normal washing detergent, dishwasher, or foam bath. Clean gently with palm and beware of fingernails and coarse materials which might affect or scratch its surface. When dried, apply with powder provided or cornstarch powder. The model will be as good as new again. We strongly recommend the periodical maintenance of your model.

9. Should the model’s surface experienced scratch, cut or poke, please use supplied TPE glue to seal. The clean defected area with makeup remover before gluing. Make sure the defected surface is not in tension when applying TPE glue. Curing time is approximately half an hour.

Should you have any other doubts about the technical aspects of maintaining the model, please do not hesitate to contact us at info@mylovedollmates.com for further assistance.

Message Us